Fendt 500 GEN3 Maintenance Schedules

Go Back to Maintenance Schedules

Engine

Top
Job Notes Part Quantity
Check engine heat shielding for trapped debris
Check exhaust DPF/catalyst shield hardware
Check engine oil level 10W40 Deutz Engine Oil
Drain water from fuel pre-filter
Check air filter maintenance code
Check engine air intake system for leaks
Check and clean cooling radiators and fan
Check for coolant system leaks
Check belt condition and tension, replace if necessary

Transmission

Top
Job Notes Part Quantity
Check transmission oil level 821XL Hyd. Trany Fluid
Change transmission pressure filter and o-ring 1

Front Axle & PTO

Top
Job Notes Part Quantity
Check front axle toe-in 0-2mm (0.0 to 0.08")
Check oil level in front PTO 821XL Hyd. Trany Fluid
Change front axle differential oil 80W90 Gear Oil. 80W90 9L
Change gasket in front differential 2
Change oil in front axle hubs 80W90 Gear oil 80W90 2L
Change front hub gaskets 2

Hydraulics

Top
Job Notes Part Quantity
Check hydraulic oil level 821XL Hyd. Trany Fluid
Drain oil from couplers' oil recovery bottles As required.

Cab

Top
Job Notes Part Quantity
Clean the a/c condenser As required.
Check and Adjust A/C compressor belt As required.
Windshield washer reservoir Refill as needed. APC 15-204 1

Compressed Air System

Top
Job Notes Part Quantity
Compressed air function/leak test
Operate tank drain valve
Check antifreeze level

Electrical System

Top
Job Notes Part Quantity
Check lighting, signaling, and warnings systems for correct operation
Check software version, and update if necessary
Check battery acid level
Read out, record diagnostic memory & remedy faults

General

Top
Job Notes Part Quantity
Tighten wheel hardware to specifications
Check for loose hardware, linkages; check for leaks
Check tire pressure
Lubricate all grease points 1
Test drive tractor, checking functions & braking systems
Check brake control
Check electro-hydraulic steering

Wheel Nut Torque Specifications

Top
Job Notes Part Quantity
Front wheel center to hub 203 ft/lbs (275NM)
Front wheel rim to dish 207 ft/lbs (280NM)
Rear wheel center to hub 332 ft/lbs (450NM)
Rear wheel hub tapers to axle (3 step tightening) 442 ft/lbs (600NM)
Rear wheel rim to dish 206 ft/lbs (280NM)
Wheel Weight, Rear/Tapered Cones – (M16 Bolt) Torque Spec 195 ft/lbs. with M16 Bolts
 The following parts are not in stock:
  • 80W90
  • APC 15-204

Contact Us Regarding Stock:

Purchase Parts

 Listed bellow are some of the parts that you may need for servicing your equipment. You can purchase them all, uncheck the ones you don’t feel are needed, or increase/decrease the quantities we’ve recommended.

Transmission

Top
Job Part Quantity Add to Cart
Change transmission pressure filter and o-ring 72659254 Transmission Filter

Front Axle & PTO

Top
Job Part Quantity Add to Cart
Change gasket in front differential 72315103 Sealing Ring
Change front hub gaskets 72315103 Sealing Ring