Fendt 700 COM1 Maintenance Schedules
Go Back to Maintenance Schedules
Engine
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Change engine oil | 15W-40 Engine oil. | 15W-40 | 17L |
| Change engine oil filter | 1 | ||
| Oil drain plug gasket | 1 | ||
| Change fuel filter | 1 | ||
| Change engine air primary filter | 1 | ||
| Change engine air secondary filter | 1 | ||
| Check the engine coolant level | Premixed FleetGuard Antifreeze | ||
| Check engine belts | |||
| Check engine valve clearance | |||
| Check engine air intake system for leaks | |||
| Clean debris from engine ring fan | |||
| Change crankcase breather filter | 1 |
Transmission
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Check fluid level for clutch/brake actuation | 72313538 | ||
| Change transmission oil | 821XL Hyd/ Trany Fluid 712, 714 and 716 take 43L. | 821XL | 45L |
| Change transmission pressure filter and o-ring | 1 | ||
| Change transmission suction filter and o-ring | 1 | ||
| Change drain plug gaskets | 2 | ||
| 1 | |||
| Change the oil in rear axle final drives | 80W-90 Gear Oil. Each side takes 10.5L. | 80W-90 | 21L |
| Change drain plug gasket in final drives | 4 |
Front Axle & PTO
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Change oil in front PTO | 821XL Hyd./Trany Fluid | 821XL | 4L |
| Change front axle differential oil | 80W-90 Gear Oil. | SRM 742508 | 2 |
| 80W-90 | 7L | ||
| Change gasket in front differential | 2 | ||
| Change oil in front axle hubs | 80W-90 Gear Oil.1L per side. | 80W-90 | 2L |
| Change front hub gaskets | 2 | ||
| Check front axle toe-in | 0 to 1mm (0 to 0.04") | ||
| Grease front axle driveline |
Hydraulics
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Change hydraulic oil | 821XL Hyd./Trany Fluid | 821XL | 50L |
| Drain plug o-ring | 1 | ||
| Change Dipstick O-ring | HER 568-114 | 1 | |
| Change hydraulic return line filter | Prior uses the 250mm filter: 72426554.Effective uses the 300mm filter:72426561.Effective with 712/22/5651, 714/22/5782 and 716/22/6543. | 1 | |
| 1 | |||
| Change hydraulic reservoir breather | 1 |
Cab
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Change fresh air filter | 2 | ||
| Change recirculating air filter | Prior uses the filter 72478600.Effective uses the two filters: 72426606.Effective with 712/22/5494, 714/22/5600 and 716/22/6177. | 2 | |
| 1 | |||
| Change heater air filter | 1 | ||
| Windshield washer reservoir | Refill as needed. | APC 15-204 | 1 |
Compressed Air System
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Check antifreeze level | |||
| Drain Water from Air System |
Electrical System
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Check lighting, signaling, and warnings systems for correct operation | |||
| Check battery acid level | |||
| Read out, record diagnostic memory & remedy faults |
General
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Tighten wheel hardware to specifications | |||
| Check for loose hardware, linkages; check for leaks | |||
| Test drive tractor, checking functions & braking systems | |||
| Check tire pressure | |||
| Lubricate all grease points | 1 |
Wheel Nut Torque Specifications
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Front wheel center to hub | 199 ft/lbs (270 NM) | ||
| Front wheel rim to dish | 207 ft/lbs (280 NM) | ||
| Rear wheel center to hub | 457 ft/lbs (620 NM) | ||
| Rear wheel hub tapers to axle (3 step tightening) | 442 ft/lbs (600 NM) | ||
| Rear wheel rim to dish | 206 ft/lbs (280 NM) | ||
| Wheel Weight, Rear/Tapered Cones – (M16 Bolt) Torque Spec | 195 ft/lbs. with M16 Bolts |