Fendt 700 GEN7 Maintenance Schedules

Go Back to Maintenance Schedules

Engine

Top
Job Notes Part Quantity
Check engine heat shielding for trapped debris
Check engine oil level 10W40 Mann Engine Oil
Check air filter maintenance code
Check hose clamps on coolant and air intake system
Check and clean cooling radiators and fan
Check for coolant system leaks
Check engine belts

Transmission

Top
Job Notes Part Quantity
Check transmission oil level 821XL Hyd. / Trans Fluid
Check oil level in rear axle final drives Fill to overflow mark at filler hole.
Change transmission pressure filter and o-ring 72659254 1

Front Axle & PTO

Top
Job Notes Part Quantity
Check oil level in front PTO 821XL Hyd. / Trans Fluid
Change front axle differential oil 80W90 79036959B 9L
Front axle drain plug gasket 72315103 2
72376044 4
Change oil in front axle hubs 80W90 79036959B 8L
Check front axle toe-in
inspect steering hyd. lines

Hydraulics

Top
Job Notes Part Quantity
Check hydraulic oil level 821XL Hyd. / Trans Fluid
Clean the hydraulic remote couplings As required.
Drain oil from couplers' oil recovery bottles

Cab

Top
Job Notes Part Quantity
Clean the a/c condenser As required
Check and Adjust A/C compressor belt
Check operation of the A/C system
Windshield washer reservoir Refill as needed. 15-204 1

Compressed Air System

Top
Job Notes Part Quantity
Operate tank drain valve
Compressed air function/leak test

Electrical System

Top
Job Notes Part Quantity
Read out, record diagnostic memory & remedy faults
Check software version, and update if necessary
Check lighting, signaling, and warnings systems for correct operation
Check battery acid level
Check the operation of the safety start switches

General

Top
Job Notes Part Quantity
Tighten loader mounting hardware to specifications
Tighten wheel hardware to specifications
Check for loose hardware, linkages; check for leaks
Visually check the Panhard rod brgs for cab / signs of wear
Check tire pressure
Lubricate all grease points 79014728B 1
Inspect towing equipment
Inspect three point linkage
Check front steering, hyd. systems' hoses' wear & leaks
Check safety guards – correctly & securely installed
Check if safety decals are in place and legible
Test drive tractor, checking functions & braking systems
After road test check for leaking oils, fuel or coolant

Wheel Nut Torque Specifications

Top
Job Notes Part Quantity
Front wheel center to hub
Front wheel rim to dish
Rear wheel center to hub
Rear wheel hub tapers to axle (3 step tightening)
Rear wheel rim to dish
Wheel Weight, Rear/Tapered Cones – (M16 Bolt) Torque Spec 195 ft/lbs. with M16 Bolts