Fendt 1000 GEN2 Maintenance Schedules

Go Back to Maintenance Schedules

Engine

Top
Job Notes Part Quantity
Check engine oil level 10W40 Mann Engine Oil
Drain water from fuel filter
Drain water from fuel pre-filter
Check the engine air filter restriction in terminal As required.
Check and clean cooling radiators and fan As required.
Check the engine coolant level 50/50 mix Mann Coolant (sells by the 4 litre jug) Maple Lane recommends Mann Coolant for Mann Engines
Check for coolant system leaks As required.
Check engine belts As required.
Check engine air intake system for leaks As required.

Transmission

Top
Job Notes Part Quantity
Check transmission oil level If not to correct level, determine cause. 821XL Hyd. / Trany Fluid
Change transmission pressure filter and o-ring O-ring is 72313495 72659255 1
Check oil level in rear axle final drives Gear Oil If not to correct level, determine cause. 61mm (2.4 inches;) below the filler hole.18L per side

Front Axle & PTO

Top
Job Notes Part Quantity
Change front axle differential oil 821XL Extended Life Hyd/Transmission Fluid 72376044 1
79035451B 15L
Change oil in front axle hubs Gear oil (5.5L per side). 79036959B 11L
Change front hub gaskets Agco does not supply a part MOR-18.8X2.4 4
Change front axle pressure filter and O-ring O-ring is 72313494 72663318 1
Check front axle toe-in Adjust if necessary.

Hydraulics

Top
Job Notes Part Quantity
Check hydraulic oil level If not to correct level, determine cause. 821XL Hyd. / Trany Fluid
Drain oil from couplers' oil recovery bottles As required.

Cab

Top
Job Notes Part Quantity
Clean the a/c condenser As required.
Windshield washer reservoir Refill as needed. 15-204 1

Compressed Air System

Top
Job Notes Part Quantity
Compressed air function/leak test
Drain Water from Air System

General

Top
Job Notes Part Quantity
Test drive tractor, checking functions & braking systems As required.
Check tire pressure Adjust if required.
Lubricate all grease points As required. 79014728B 1
Inspect towing equipment
Inspect three point linkage
Check front steering, hyd. systems' hoses' wear & leaks

Wheel Nut Torque Specifications

Top
Job Notes Part Quantity
Front wheel center to hub 430 ft/lbs (580NM)
Rear wheel center to hub 457 ft/lbs (620NM)
Rear wheel hub tapers to axle (3 step tightening) 428 ft/lbs (580NM)
Wheel Weight, Rear/Tapered Cones – (M16 Bolt) Torque Spec 195 ft/lbs. with M16 Bolts