Fendt 300 GEN4 Maintenance Schedules

Go Back to Maintenance Schedules

Engine

Top
Job Notes Part Quantity
Check engine heat shielding for trapped debris
Perform stationary regeneration of DPF Stationary regen must always be done before changing engine oil. Note; regen is initiated through TCD!
Change engine oil filter 1
Change engine oil 10W40 Mann Engine Oil 10W40 14L
Oil drain plug gasket 1
Drain water from fuel pre-filter
Inspect the DEF breather filter, and blow out hose
Check air filter maintenance code
Check engine air intake system for leaks
Check engine air filters Clean Out (Advise if replacement needed) 72614435 Outer, V36539700 Inner
Empty dust discharge valve
Check and clean cooling radiators and fan
Check for coolant system leaks
Check engine belts
Check exhaust DPF/catalyst shield hardware

Transmission

Top
Job Notes Part Quantity
Check fluid level for clutch/brake actuation 72313538 Pentosin Fluid
Check transmission oil level 821XL Hyd. Trany Fluid
Change transmission pressure filter and o-ring 1
Change transmission and final drive oil tranny section incomplete

Front Axle & PTO

Top
Job Notes Part Quantity
Check oil level in front PTO If equipped 821XL Hyd. Trany Fluid
Change front axle differential oil 80W90Gear Oil 8
Change gasket in front differential 2
1
Change oil in front axle hubs 80W90Gear Oil 2
Change front hub gaskets 2
Check front axle toe-in

Hydraulics

Top
Job Notes Part Quantity
Check hydraulic oil level 821XL Hyd. Trany Fluid
Drain oil from couplers' oil recovery bottles

Cab

Top
Job Notes Part Quantity
Clean the a/c condenser
Check and Adjust A/C compressor belt
Windshield washer reservoir Refill as needed. APC 15-204 1

Compressed Air System

Top
Job Notes Part Quantity
Compressed air function/leak test
Operate tank drain valve

Electrical System

Top
Job Notes Part Quantity
Check lighting, signaling, and warnings systems for correct operation
Check software version, and update if necessary
Read out, record diagnostic memory & remedy faults

General

Top
Job Notes Part Quantity
Tighten wheel hardware to specifications
Check for loose hardware, linkages; check for leaks
Clean the cab air springs area
Check tire pressure
Lubricate all grease points 1
Tighten loader mounting hardware to specifications
Test drive tractor, checking functions & braking systems
Check electro-hydraulic steering
Check brake control

Wheel Nut Torque Specifications

Top
Job Notes Part Quantity
Front wheel rim to dish
Rear wheel center to hub
Rear wheel hub tapers to axle (3 step tightening)
Rear wheel rim to dish
Front wheels
Rear wheels
Wheel Weight, Rear/Tapered Cones – (M16 Bolt) Torque Spec 195 ft/lbs. with M16 Bolts
 The following parts are not in stock:
  • 10W40
  • APC 15-204

Contact Us Regarding Stock:

Purchase Parts

 Listed bellow are some of the parts that you may need for servicing your equipment. You can purchase them all, uncheck the ones you don’t feel are needed, or increase/decrease the quantities we’ve recommended.

Engine

Top
Job Part Quantity Add to Cart
Change engine oil filter V836679586 Engine Oil Filter
Oil drain plug gasket V615881827 Seal

Transmission

Top
Job Part Quantity Add to Cart
Change transmission pressure filter and o-ring 72659254 Transmission Filter

Front Axle & PTO

Top
Job Part Quantity Add to Cart
Change gasket in front differential 72315103 Sealing Ring
72376449 O-Ring
Change front hub gaskets 72315103 Sealing Ring