Fendt 700 GEN6 Maintenance Schedules

Go Back to Maintenance Schedules

Engine

Top
Job Notes Part Quantity
Check engine oil level 10W40 Deutz Engine Oil
Drain water from fuel pre-filter
Check air filter maintenance code
Check engine air intake system for leaks
Check engine air filters Clean Out (Advise if replacement needed) 72614248 Outer, 72626309
Check and clean cooling radiators and fan
Check the engine coolant level
Check for coolant system leaks
Check engine belts

Transmission

Top
Job Notes Part Quantity
Check transmission oil level 821XL Hyd. / Trans Fluid
Check oil level in rear axle final drives 85W140 Gear Oil 14L per side
Change transmission pressure filter and o-ring 1

Front Axle & PTO

Top
Job Notes Part Quantity
Check oil level in front PTO
Change front axle differential oil 80W90 Gear Oil 80W90 9L
Change gasket in front differential 4
Change oil in front axle hubs 80W90 Gear oil (2L per side) 80W90 4L
Check front axle toe-in

Hydraulics

Top
Job Notes Part Quantity
Check hydraulic oil level
Clean the external pressure supply sieve filter As Required
Drain oil from couplers' oil recovery bottles As Required

Cab

Top
Job Notes Part Quantity
Clean the a/c condenser
Check and Adjust A/C compressor belt
Windshield washer reservoir Refill as needed. APC 15-204 1

Compressed Air System

Top
Job Notes Part Quantity
Operate tank drain valve
Check antifreeze level ? does this always apply? or never?
Drain Water from Air System
Compressed air function/leak test

Electrical System

Top
Job Notes Part Quantity
Check lighting, signaling, and warnings systems for correct operation
Check software version, and update if necessary
Read out, record diagnostic memory & remedy faults

General

Top
Job Notes Part Quantity
Tighten wheel hardware to specifications
Check for loose hardware, linkages; check for leaks
Test drive tractor, checking functions & braking systems
Check tire pressure
Lubricate all grease points 1
Tighten loader mounting hardware to specifications

Wheel Nut Torque Specifications

Top
Job Notes Part Quantity
Front wheel center to hub 331 ft/lbs (448 NM)
Rear wheel center to hub 427 ft/lbs (578 NM)
Front wheel rim to dish
Rear wheel hub tapers to axle (3 step tightening)
Rear wheel rim to dish
Wheel Weight, Rear/Tapered Cones – (M16 Bolt) Torque Spec 195 ft/lbs. with M16 Bolts
 The following parts are not in stock:
  • 80W90
  • APC 15-204

Contact Us Regarding Stock:

Purchase Parts

 Listed bellow are some of the parts that you may need for servicing your equipment. You can purchase them all, uncheck the ones you don’t feel are needed, or increase/decrease the quantities we’ve recommended.

Transmission

Top
Job Part Quantity Add to Cart
Change transmission pressure filter and o-ring 72659254 Transmission Filter

Front Axle & PTO

Top
Job Part Quantity Add to Cart
Change gasket in front differential 72376470 O-Ring