Go Back to Maintenance Schedules
| Job | Notes | Part | Quantity |
|---|---|---|---|
| Perform stationary regeneration of DPF | Stationary regen must always be done before changing the engine oil. | ||
| Change engine oil | 10W40 Deutz Engine Oil | 79036470B | 16L |
| Change engine oil filter | ACO F836200510080 | 1 | |
| Oil drain plug gasket | ACO F731200510060 | 1 | |
| Change fuel filter | Most later serial numbers take 72666152 | ACO F340200060160 | 1 |
| ACO F340200060180 | 1 | ||
| Change fuel pre-filter | ACO F842201060010 | 1 | |
| Change the DEF filter | 1 | ||
| Change DEF breather filter, blow out hose | ACO H835200730200 | 1 | |
| Change the DEF sensor pre-filter | Includes filter, clip (ACP0338341) and O-ring (ACP0338342). | 1 | |
| 1 | |||
| DEF Sensor O-Ring / Tank seal | APC0222090 | ||
| Check air filter maintenance code | |||
| Check engine air intake system for leaks | |||
| Change engine air primary filter | ACO H743200090100 | 1 | |
| Change engine air secondary filter | ACO F743200090200 | 1 | |
| Check and clean cooling radiators and fan | |||
| Check for coolant system leaks | |||
| Change Engine Coolant | CC2826 | 28L | |
| Change coolant drain plug gasket | ACO X540002478000 | 1 | |
| Check engine belts | |||
| Check engine valve clearance | ACO 725200010251 | 1 |
| Job | Notes | Part | Quantity |
|---|---|---|---|
| Check transmission oil level | 821XL Hyd. / Trans Fluid | ||
| Change transmission oil | 821XL Hyd. / Trans Fluid | 79035451B | 49L |
| Change drain plug gaskets | ACO X540009478000 | 2 | |
| ACO X540010278000 | 1 | ||
| Change the oil in rear axle final drives | 85W140 Gear Oil 14L per side | 85W140 | 28L |
| Change drain plug gasket in final drives | ACO X540009478000 | 4 | |
| Change transmission pressure filter and o-ring | O-Ring is 72313495 | ACO F91610060001A | 1 |
| Change transmission suction filter and o-ring | O-Ring is 72424095 | ACO F916100490010 | 1 |
| Job | Notes | Part | Quantity |
|---|---|---|---|
| Change oil in front PTO | 821XL Hyd. / Trans Fluid | 79037113B | 4L |
| Change filter in front PTO | O-Ring is 72376561 If applicable | ACO 716150200160 | 1 |
| Change gaskets in front PTO | ACO X540008278000 | 2 | |
| Change front axle differential oil | 80W90 Gear Oil | 79036959B | 9L |
| Change gasket in front differential | ACO X548864900000 | 4 | |
| Change oil in front axle hubs | 80W90 Gear oil (2L per side) | 79036959B | 4L |
| Check front axle toe-in |
| Job | Notes | Part | Quantity |
|---|---|---|---|
| Change hydraulic oil | 821XL Hyd. / Trans Fluid | 79035451B | 80L |
| Drain plug o-ring | ACO X548842900000 | 1 | |
| Change hydraulic vent filter | ACO F835860061020 | 1 | |
| Change hydraulic return line filter | ACO G835860061040 | 1 | |
| Change control pressure fine filter | ACO F737960020060 | 1 | |
| Clean the external pressure supply sieve filter | As Required | ||
| Drain oil from couplers' oil recovery bottles | As Required |
| Job | Notes | Part | Quantity |
|---|---|---|---|
| Change fresh air filter | ACO H737812140010 | 1 | |
| Change recirculating air filter | ACO H350810140080 | 1 | |
| ACO H737812140050 | 1 | ||
| Clean the a/c condenser | |||
| Check and Adjust A/C compressor belt | |||
| Windshield washer reservoir | Refill as needed. | 15-204 | 1 |
| Job | Notes | Part | Quantity |
|---|---|---|---|
| Operate tank drain valve | |||
| Drain Water from Air System | |||
| Change Air Dryer Cartridge | ACO F842880141020 | 1 | |
| Compressed air function/leak test |
| Job | Notes | Part | Quantity |
|---|---|---|---|
| Check lighting, signaling, and warnings systems for correct operation | |||
| Check software version, and update if necessary | |||
| Check batteries for corrosion or loose connections | |||
| Check battery acid level | |||
| Read out, record diagnostic memory & remedy faults |
| Job | Notes | Part | Quantity |
|---|---|---|---|
| Tighten wheel hardware to specifications | |||
| Check for loose hardware, linkages; check for leaks | |||
| Test drive tractor, checking functions & braking systems | |||
| Check tire pressure | |||
| Lubricate all grease points | 79014728B | 1 | |
| Tighten loader mounting hardware to specifications | |||
| Brake Clean for cleanup | 890.9107 | 1 |
| Job | Notes | Part | Quantity |
|---|---|---|---|
| Front wheel center to hub | 331 ft/lbs (448 NM) | ||
| Front wheel rim to dish | |||
| Rear wheel center to hub | 430 ft/lbs (580 NM) | ||
| Rear wheel hub tapers to axle (3 step tightening) | 340 ft/lbs. (459 NM) | ||
| Rear wheel rim to dish | |||
| Wheel Weight, Rear/Tapered Cones – (M16 Bolt) Torque Spec | 195 ft/lbs. with M16 Bolts |
Contact Us Regarding Stock: