Fendt 900 COM2 Maintenance Schedules
Go Back to Maintenance Schedules
Engine
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Change engine oil | 15W-40 Engine Oil | 15W-40 | 25L |
| Change engine oil filter | 1 | ||
| Oil drain plug gasket | 2 | ||
| Change fuel filter | 2 | ||
| Change fuel pre-filter | 1 | ||
| Change fuel pump pre-filter | 1 | ||
| Change engine air primary filter | 1 | ||
| Change engine air secondary filter | 1 | ||
| Check the engine coolant level | Premixed FleetGuard Antifreeze | ||
| Check engine air intake system for leaks | |||
| Clean debris from engine ring fan | |||
| Check water pump bearings & leaks at weep hole | |||
| Remove belts, check idler, tensioner bearings + belts |
Transmission
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Check fluid level for clutch/brake actuation | 72313538 Pentosin Fluid | ||
| Change transmission oil | 821XL Hyd. / Trany Fluid | 821XL | 66L |
| Change transmission pressure filter and o-ring | 1 | ||
| Change transmission suction filter and o-ring | 1 | ||
| Change drain plug gaskets | 2 | ||
| 1 | |||
| Check oil level in rear axle final drives | 85W-140 Gear Oil | ||
| Check for brake drag with rolling stop test |
Front Axle & PTO
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Change oil in front PTO | 85W-140 Gear Oil. If equipped. | 85W-140 | 5L |
| Change filter in front PTO | If equipped. | ||
| Change front axle differential oil | 80W-90 Gear Oil. | 80W-90 | 10L |
| Change oil in front axle hubs | 80W-90 Gear Oil. Each side takes 3L. | 80W-90 | 6L |
| Front axle drain plug gasket | 4 |
Hydraulics
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Change hydraulic oil | 821XL Hyd./Trany Fluid | 821XL | 71L |
| Drain plug gasket | 1 | ||
| Change hydraulic return line filter | 1 | ||
| Change hydraulic reservoir breather | 1 | ||
| Service Endplate / Test Accumulator | 1 |
Cab
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Change fresh air filter | 2 | ||
| Change recirculating air filter | 2 | ||
| Change heater air filter | 1 | ||
| Windshield washer reservoir | Refill as needed. | APC 15-204 | 1 |
Compressed Air System
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Check antifreeze level | |||
| Compressed air function/leak test | |||
| Drain Water from Air System |
Electrical System
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Check lighting, signaling, and warnings systems for correct operation | |||
| Check battery acid level | |||
| Read out, record diagnostic memory & remedy faults | |||
| Check software version, and update if necessary | |||
| Check batteries for corrosion or loose connections |
General
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Tighten wheel hardware to specifications | |||
| Check for loose hardware, linkages; check for leaks | |||
| Lubricate all grease points | 1 | ||
| Brake Clean for cleanup | SRM 890.9107 | 1 | |
| Check tire pressure | |||
| Test drive tractor, checking functions & braking systems |
Wheel Nut Torque Specifications
Top| Job | Notes | Part | Quantity |
|---|---|---|---|
| Front wheel center to hub | 199 ft/lbs (270 NM) | ||
| Front wheel rim to dish | 173 ft/lbs (235 NM) | ||
| Rear wheel center to hub | 457 ft/lbs (620 NM) | ||
| Rear wheel hub tapers to axle (3 step tightening) | 442 ft/lbs (460 NM) | ||
| Rear wheel rim to dish | 206 ft/lbs (280 NM) | ||
| Wheel Weight, Rear/Tapered Cones – (M16 Bolt) Torque Spec | 195 ft/lbs. with M16 Bolts |